|No. 501, Changsheng South Road, Occident Biotechnology Industry Park, Jiaxing, Zhejiangfirstname.lastname@example.org|
Payment & Shipping Terms:
|Material:||2507 / 2205 / 31803 / 32750||Type:||Seamless|
|Technology:||Cold Rolled||Condition:||Soft / Hard|
SAF 2507 / 1.4410 Duplex Pipe With Fixed Length, ISO 9001
|Material Grade||S32205 , S31803 , S32304 , S32750, F51 , F53 , 2205 , 2507 etc|
|Outer Diameter||10.3mm - 1219mm (1/8" to 48")|
|Wall Thickness||1.24mm - 59.54mm (1/8" to 24")|
|Length||as per customer’s requirement|
|Standard||ASTM A789 ; ASTM A790 ; EN 10216-5ect .|
20ft GP : 5898mm ( Length ) x 2352mm ( Width ) x 2393mm ( High )
40ft GP : 12032mm ( Length ) x 2352mm ( Width ) x 2393mm ( High )
40ft HC : 12032mm ( Lengh ) x 2352mm ( Width ) x 2698mm ( High )
20 feet container load 25tons coils whose length is under 5.8m
40 feet container load 25tons coils whose length is under 11.8m
SAF 2507 / 1.4410 is a super duplex stainless steel with 25% chromium, 4% molybdenum, 7% nickel . This kind of pipes always purchased by the clients who are require exceptional strength and corrosion resistance .
The steel has excellent resistance to chloride stress corrosion cracking, high thermal conductivity and a low coefficient of thermal expansion. And the high chromium, molybdenum, and nitrogen levels provide excellent resistance to pitting, crevice, and general corrosion.
Most of 2507 / 1.4410 duplex steel pipes are produced by cold drawn method . The alloy has higher yield strength and lower ductility than austenitic steels so fabricators may fid that higher forming forces , increased radius of bending , and increased allowance for springback are necessary . Deep drawing , stretch forming , and similar processes are more difficult to perform on 2507 than on an austenitic stainless steel . When forming requires more than 10% cold deformation , a solution anneal and quench are recommended . And finished cold drawn duplex steel pipe , manufacturer should be solution annealed and quenched . The minimum annealing tempeture is 19250F . Annealing should be followed immediately by a rapid air or water quench. To obtain maximum corrosion resistance, heat treated products should be pickled and rinsed .